ADVERTISEMENT | ADVERTISE WITH US
0
Sept. 21, 2016, 12:27 p.m.
By Aaron Waldron
LiveRC.com
From David Ronnefalk (via Facebook):
Tip of the week!
I've had lots of questions about how I made my switch with a jumper of two 4mm bullet plugs! While building my
HB Racing radio tray for the Worlds today, I took some photos of how I do it.
STEP 1: Mount your servos to the radio tray as you like.
STEP 2: Use your reamer to make two holes on the side of the radio tray. Make sure to make the holes in the right size of your female plugs. I use the female plugs from Dynamax.
STEP 3: Use a heavy duty extension wire about 200mm long. Remove the white wire. Cut either the black or red wire in half or so that one side reaches the battery. Twist it around the outside of the female plug and solder it together. I put shrink tubes over it for protection.
STEP 4: Install your receiver and transponder. Make sure to put some protection foam to prevent the receiver/transponder for moving around inside while driving.
Boom! You're pretty much bullet proof switch for your
D815 V2 buggy is done! You will just have to make a small jumper and then you are ready to go!
Eng / Usd
Français
Deutsch
Italiano
Recent comments