PSM carbon fiber shock towers for MBX7R

0 March 23, 2016, 12:47 p.m.

By Aaron Waldron
LiveRC.com

New from PSM:
www.psm-rc.com

Shock Tower, Carbon 5mm - MBX7R (1)
Front - #PS01735, €26.95
Rear - #PS01736, €29.95

These 5mm thick carbon shock towers were designed to replace the original front and rear shock towers of Mugen Seiki's MBX7R. Due to the lower weight compared to the stock shock towers it will lower the center of gravity.

5.0mm Thickness - with true carbon layers inside.
Authentic PSM Carbon - superior material quality. high impact resistance.semi-gloss look.
Lightweight - at only 17.0g (front) and 23.0g (rear)
Lowers Center of Gravity
Direct Fit - the stock part can be replaced directly without any problem.
Designed and precision machined by PSM in Germany.

Important Notes:

We recommend you seal the edges of the carbon fiber product with CA glue prior to use.
The total thickness of this carbon product can vary by +-0.3mm as of manufacturing tolerances.
Milling grooves may vary in deepness as of manufacturing tolerances.
According to our policy of steady development and improvement of our products, we reserve the right to make changes in specifications concerning equipment, materials and design of this product at any time without notice.
The edges of this product may be a little sharp in exceptional cases, please check our sealing recommendation for more details.
You may darken the milling grooves with wiping oil over the surface.
This is a performance product, it is intended to use for professional purpose only. PSM will not be responsible for any loss or damage whatsoever caused while using PSM products.
Please race your R/C cars on special designed tracks and join a local R/C club to receive proper insurance.