3DGY printed rear arm mount inserts for B5M

ADVERTISEMENT | ADVERTISE WITH US

---

By Aaron Waldron
LiveRC.com

New from 3DGY:
www.3dgydesigns.com

3DGY - Team Associated B5M, T5M, SC5M High & Low Roll Center Rear Arm Mount Inserts: Standard or +2mm Pivot Width - $8.00

New 3D printing company 3DGY has just released these Team Associated rear arm mount insert kits, allowing for the rear roll center of the B5M, T5M, or SC5M vehicles to be adjusted by raising or lowering the rear inner hinge pin height by +/- 0.6mm relative to the standard kit arm mount insert height (the maximum allowable vertical distance within the insert shape and size).

Kits are offered in a Standard or +2mm rear width offset. The Standard inserts can be used in the Team Associated Factory Team +4mm C block as well for a +4mm pivot offset.

Both Standard and +2mm kits are precision 3D printed with high quality filament and settings with the popular 3° toe-in, with 1° and 2° degree anti-squat options, as marked on the C-block inserts.

All C Block inserts are marked as follows, specifying High or Low roll center orientation with their corresponding anti-squat angle:

• LI: Low roll center 1° squat.
• LII: Low roll center 2° squat.
• HII: High roll center, 1° squat.
• HI: High roll center 2° squat.

Lowering the rear roll center increases grip on lower bite conditions, or when more overall rear grip is desired.

Raising the rear roll center generally takes away rear grip, however it can make the car easier to drive on high grip conditions because it has less tendency to flip and feels less locked in (less 3dgy!).

Check out www.3dgydesigns.com for more information. Available now!

 

Photo Gallery