New Hobbywing XROTOR M-Series drone racing ESCs

0 July 27, 2016, 6 p.m.

By Aaron Waldron
LiveRC.com

New from Hobbywing:
www.hobbywingdirect.com

BLHeli Firmware Ready

Users can flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after connecting their flight controller to the BLHeli Suite software if the flight controller uses the CleanFlight firmware.

Damped Light Mode & OneShot125 Mode Supported

Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling technology improves driving efficiency, flight time and heat dissipation. The ESCs support OneShot125 high-speed throttle signal and regular throttle signal (within 500Hz) modes

ModelBLHeli 20A 2-4SBLHeli 30A 2-4S

BLHeli 35A 3-6S

SKU

309010663090107130901070ApplicationFPVs with 130-280mm Diagonal WheelbaseFPVs with 130-280mm Diagonal WheelbaseFPVs with 150-330mm Diagonal WheelbaseLiPo Power input2S-4S2S-4S3S-6S

Cont.Current

20A30A35ABurst Current30A40A50A (burst in 10 sec)BEC Output

N/AN/A

N/A

Input wires20AWG-100mm* (Red/Black)18AWG-100mm* (Red/Black)

18AWG-100mm* (Red/Black)

Output WireSolder tabs (no wires)Solder tabs (no wires)Solder tabs (no wires)Connectors
(In/Out)no (raw wires)nonoWeight / Size7g/24.0x13.9x5.5mm7g/24.0x13.9x5.5mm10g/36.5x16.7x5.5mm

* Note: All the wire length above is the original length, not the length you see from the outside.