MIP's delivers in the clutch with 8-shoe 1/5-scale driveline upgrade

LONGER-LASTING, PUNCHIER, LIGHTER, and REBUILDABLE! These four descriptive words embody what MIP’s new 1/5th scale clutch is all about. As any well aware and conscientious 1/5 scalier knows, the stock clutch is non-rebuildable, its heavy, loses its edge in the first 15 minutes and fades quickly after, and most of all it takes a long time for the motor to spool up and the clutch to engage properly. With all these downfalls and swapping out $30 clutches every couple heats, it was much past due for a little MIP Magic. With months of direct input from MIP’s Engineering and Race Team we have come up with a true racing clutch that is superior to that of the stock clutch. MIP’s 1/5th Scale 54mm Racing Clutch hits harder faster, its shoe longevity is vastly improved, and when shoes and springs do wear out, there’s no need to ditch the entire assembly as it is completely rebuildable! It’s not a question as to whether you need this clutch, but rather are you going to have it before your competition does? We welcome you to an all-new 1/5th scale reality; MIP’s reality!

 

 

 

TARGET CUSTOMERS:

1/5th Scale Customers

 

COMPETITIVE ADVANTAGES: When compared to OEM clutch

Quicker acceleration

50% less rotating mass

Shoe Longevity is vastly improved

Clutch fade is little to non-existent

Clutch hits harder faster

 

FEATURES:

7075 aluminum construct

8-Shoe design

4, 6, or 8 shoe adjustability

Completely rebuildable

100% Made in the USA

 

INCLUDES:

MIP Confetti Sticker (2), MIP Instructions Sheet (1), SHCS M6 x 16mm Cap Screw (1), BHCS M3 x 6mm Button Head Screw (4), Spring 0-Deg Clutch (8), SHSS M12 X 12mm Set Screw (1), MIP Aluminum Flywheel (1), MIP Clutch retainer Plate (1), MIP Clutch Shoe (8), MIP Blue Thread Gel (1)

 

COMPATIBILITY:

Engines that except 54mm clutches*, 1/5 Losi 5ive-T 4WD Off-Road Truck (#LOSB0019), Losi 1/5 Desert Buggy (LOS05001), Losi 1/5 MINI WRC 4wd Rally Car RTR (LOS05007), 1/5 Redcat Rampage Series, Zenoah 1/5 scale engines*,  Bartolone Racing 1/5 scale engines*, OBR Engines*.

 

*IMPORTANT: Some engines (usually 32cc and up) vary on backspacing on crankshaft length so if you have had to modify the original clutch backplate to be accepted on an aftermarket engine than the MIP clutch may not be compatible. The dimensions used for the backspacing of the MIP Racing Clutch were based off of the stock Losi 1/5 scale clutch and backplate.

 

MIP 1/5th Scale, 54mm Racing Clutch, 8-Shoe, #14355