New Bittydesign CA45-M FWD M-Chassis Body

Press Release From Bittydesign:
www.bittydesign.net/en/

This project was born from the desire to expand our range of bodies for the 1/10 MINI category by offering a design that reproduces the volumes of the C segment.

The Bittydesign CA45-M fits all the 1/10 M-chassis cars on the market with 210-225mm wheelbase, and can be mounted on the 4WD chassis as well on the cars with front wheel drive (2WD).

• Made with high quality and genuine polycarbonate Lexan®
• Included in the kit a complete set of screw, nuts and large plastic washers to fix properly the rear wing
• Produced only in Light Weight version 0,75mm thickness
• Sold clear with protective film outside
• Included in the package a decal sheet pre-cut and windows mask

Inspired by the shapes of a real car, we have skillfully created enlarged TCR-style fenders by adapting the proportions and measurements necessary for use with the most common M-chassis models on the market.

The design phase took several months to finish every single particular, the attention to detail was obsessive in order to propose a body that could optimize aerodynamics in the best possible way and at the same time remain as faithful as possible to the real car of us then transformed into a "racing" version.