New SSD 2-speed transmission for Wraith

ADVERTISEMENT | ADVERTISE WITH US

---

By Aaron Waldron
LiveRC.com

New from SSD RC:
www.ssd-rc.com

2 SPEED TRANSMISSION KIT FOR WRAITH
#SSD00085

FEATURES

• CNC machined aluminum transmission case
• CNC machined aluminum 3mm thick motor mount
• Wide hardened steel 48 pitch gears
• Hardened steel output shaft
• Shift servo mount fits standard and mini servos
• Same mounting as stock Axial Wraith & SCX10 transmission
• Fits stock Axial transmission input shaft
• Fits stock Axial transmission gear cover
• Direct fit into Axial Wraith

Note:

• This is a conversion kit, not a complete transmission.

To complete the assembly it requires:

• Stock Axial transmission input shaft (AX30198 or AX31149)
• Stock 20T drive gear (AX30394, AX30162)
• Stock Axial slipper clutch assembly & spur gear
• Stock Axial transmission idler shaft  (AX31090)
• Stock Axial transmission gear cover  (AX80078)

Stock Axial transmission bearings:

• 4 *  5 x 10 x 4mm
• 5 x 10 x 11mm
• 8 x 16 x 5mm
• 15 x 21 x 4mm

Will require shifters to be removed from Wraith interior.

This can be used on an SCX10 but shorter driveshafts are required.

Assembly instructions can be found HERE:
http://ssd-rc.com/downloads/SSD%20Wraith%202%20Speed%20Assembly.pdf

Replacement output shaft is available (SSD00088)

SPECIFICATION
Internal 1st gear ratio:  4.91:1   (stock Axial is 2.6:1)
Internal 2nd gear ratio:   1.8:1
Output shaft OD:  5mm
Weight (when fully assembled with shift servo) :  335g

WHAT'S INCLUDED

• 1 X  2 Speed Transmission assembled  with motor mount
• 4 X  M3 x 10mm flat head screws
• 3 X  M2.5 x 6mm flat head screws
• 4 X  M3 x  8mm  button head screws
• 2 X  M3 x 12mm button head screws
• 1 X  M3 x 15mm threaded set screw
• 2 X  3mm mini plastic rod ends

Photo Gallery